Einzigartige Formgebung
Einzigartige Formgebung
Der Hohe Rand Schützt alle Fronteinbauten
Der Hohe Rand Schützt alle Fronteinbauten
Optimaler Schutz durch hohen Kragenrand
Optimaler Schutz durch hohen Kragenrand
Schalter und Knöpfe werden optimal geschützt
Schalter und Knöpfe werden optimal geschützt
Einzigartige Formgebung
Der Hohe Rand Schützt alle Fronteinbauten
Optimaler Schutz durch hohen Kragenrand
Schalter und Knöpfe werden optimal geschützt

conTROL

The EMC operating enclosure

IP 66, Optional: IP 67

The key product features:
• Enclosure material: diecast aluminium
• Enclosure surface: powder coating, RAL 7032
• High inner collar
• Tooth system in the bottom section for continuous contact
• Cover with high protective collar
• Sizes compatible with standard enclosures available on the market, therefore easy to exchange
• Lid screws in stainless steel 1.4567
• Enclosure seal: TPE moulded gasket

More


conTROL is a robust and versatile range of  EMC shielded aluminium enclosures which is ideal for machine control equipment. The enclosures feature in-built shielding that does not require expensive and delicate conductive gaskets. Continuous contact is created by means of a patented tooth system pre-cast into the lid and base.

Standard features include a deep recessed lid which is designed to protect buttons and control switches. The enclosures are water-tight and weather resistant to IP 66. Threaded screw bosses are provided inside for fitting circuit boards, mounting plates, terminal rails etc. Accessories such as mounting plates and cable glands are also available.

We can supply conTROL enclosures fully customised to your requirements.

Request offer PDF datasheet
Product overview Dimensions Data Sheets Data
Enclosure sizes4
Additional infoHigh shielding from radiation interference (EMC tested by the University of Hanover)
Collar protects command and information buttons
Inexpensive, as there is no need for expensive conductive gaskets
Large range of accessories
EnclosureDiecast aluminium alloy
EN AN-44300 DIN EN 1706
(GD Al Si 12/DIN 1725)
1° mould slope for casting ejection > internal circumference dimensions decrease by 1° towards enclosure bottom.
FasteningSeparate screw channels outside of the enclosure interior
Console panel integration with installation kit
Internal mountingM4 fastening thread in lateral bars on the enclosure base and optional fastening on the lid
Ingress protectionIP 66 / EN 60529 
Optional: IP 67 / NEMA 4
GasketTPE moulded gasket, silicone-free
Optional: Silicone gasket
Lid screwsStainless steel 1.4567, captive
SurfacePowder coating RAL 7032, silky grey
Optional: Special colours
Optional: Corrosion protection
CustomisingLearn more about our full customising service for installation-ready enclosures

Give us a call

+49 5751 4003-0

 

Write us

info@rolec.com

or use our
contact form

Newsletter

Hier können Sie sich zum Newsletter anmelden.